The Techspray 1665-18S is a Flux Remover AMS for Plastics. This nonflammable, high precision flux remover comes in an 18 oz aerosol spray can. It is ideally suited for sensitive plastics often used in packaging.
Flux removers (defluxers) remove flux residues and other contaminants left by manufacture, rework, or repair of printed circuit boards. Residues from higher, leadfree temperatures are more baked on and harder to clean. G3, Ecoline and PrevisionV flux removers have been proven very effective at removing fluxes baked on at leadfree temperatures. Microcomponents and fine pitch leads are delicate and easily damaged, so brushing and scrubbing should be avoided if possible. Both G3, Ecoline and PrevisionV have a powerful spray and strong solvent that blasts off residues and cleans areas under components that a brush cannot touch.
Instructions:
Maintenance cleaning: Disconnect equipment from power source. Make sure opening of sprayhead is pointing toward surface to be cleaned. Hold can 6-8 inches away. Direct spray to saturate soiled surface. A TechBrush (2000 Series) may be utilized to help in the removal of heavy soils. When used as a general cleaner, start at top of area to be cleaned using a sweeping motion and spray the area, slowly working toward the bottom. To clean in hard to reach areas, insert extension tube in sprayhead to direct spray. Allow components to dry completely before applying current.
Defluxing: Make sure opening of sprayhead is pointing toward surface to be cleaned. Hold can 15-20 cm away. Direct spray to saturate soiled surface. A TechBrush (2000 Series) may be utilized to help in the removal of heavy soils. When used as a general cleaner, start at top of area to be cleaned using a sweeping motion, and spray the area slowly, working towards the bottom. To clean in hard to reach areas, insert extension tube in sprayhead to direct spray. Allow components to dry completely before applying current. For flat surface cleaning, saturate a lint-free TechClean Twillwipe (2357) or Purwipe (2355) and wipe surface with cloth. Rotate the cleaning side of the wipe periodically and re-saturate.
Chemical & Physical Properties:
Appearance: Clear, colorless liquid
Odor: Faint ethereal odor
Flash Point: none
VOC (EPA): 5 percent (aerosol)
VOC (CARB): 75 percent (aerosol), 100 percent (bulk)
Boiling Point: 54 Degrees C (129 Degrees F)
Chemical Composition (Chemical Name / CAS #):
3,3-Dichloro-1,1,1,2,2-pentafluoropropane / 422-56-0
1,3-Dichloro-1,1,2,2,3-pentafluoropropane / 507-55-1
1,2-transdichloroethylene / 156-60-5
Methanol / 67-56-1
Nitromethane / 75-52-5
1,1,1,2-Tetrafluoroethane (aerosol) / 811-97-2
Carbon dioxide (aerosol) / 124-38-9
Please note the minimum order quantity for this item is 6
For the same item in additional sizes and packaging please see items below
Home
.jpg)
