A. Barrel type banana plug with machined contour spring support*. Crimped uniformly from
4 sides for maximum strength. Fits industry standard banana jack ≥.157”. Per ANSI/ESD
S1.1 Section 5.4, will maintain greater than 1 pound, less than five pound breakaway
force requirement over the life of the cord.
B. Thermoplastic elastomer strain relief molded on. Flex life average >50,000,000 cycles
(per ANSI/ESD S1.1 Bending Life Test, greatly exceeding the 16,000 average cycle
requirement). Break load average 30 pounds.
C. Polyurethane wire insulation. Rapid retraction coil cord compresses length with resulting
benefit of less tangling and dragging along work surface. Break load average 30 pounds.
D. Single T-3161 tinsel conductor. Consisting of 7 strands of polyester wrapped with copper.
High flex life. Equivalent is 29 gauge (cir mil and/or ohms).
E. Autosplice brass crimp secures conductors to resistor lead and provides stress relief for
resistor.
F. One megohm ±5%, 1/4 watt, series resistor limits current for operator safety. (Per ESD
S1.1 section 7.1 current limiting resistance requirement.)
G. Spring loaded 4mm medical snap socket. Spring separation .125” - .165”. Provides 1-5
pound breakaway from .160” snap stud (ANSI/ESD S1.1). Compatible with most major
brands.
H. Jewel® logo molded in compliance with ANSI/ESD S1.1.
I. Date coded with date of manufacture.
J. Underwriters Laboratory Listing 90P1C when used with Desco wristbands.
Jewel® Wrist Bands and Coil Cords meet and exceed the Wrist Band and Wrist Cord
requirements of ANSI/ESD S20.20 except that ANSI/ESD S1.1 section 5.9 states “Only wrist
straps incorporating a nonstandard [resistor] value shall use the color red on any portion of
the wrist strap.”
This coil cord comes in the following variations:
Home
.jpg)
