This premium toe grounder provides effective ESD protection. The cup is made from a black and non-marring rubber and inner tear resistant conductive scrim. The rubber is anti-static, low tribocharging, and dissipative. It removes charges when in contact when ESD protected floors. This foot grounder meets the less than 3.5 x 10 to the 6th ohm requirement of ANSI ESD S20.20. This unit includes a two megohm molded external resistor, a conductive tab with carbon suffused fibers, and a D-ring fastening system. The product has been tested to ESD STM 97.2 - Floor Materials and Footwear Voltage Measurement in Combination with a Person. It is a suitable ESD footwear component in Flooring - Footwear System when used as the primary grounding method ( lt; 3.5 x 10 to the 7th ohms per ESD STM 97.1 Floor Materials and Footwear-Resistance Measurement in Combination with a Person.)
A. 0.060" thick, 1.50" wide, black conductive exterior with a non-marring interior. tear resistant nylon reinforced 4.3 oz, inner scrim layer prevents the rubber from tearing.
B. 3/8" wide, 30" long blue polyester tab contains electrically conductive carbon suffused fibers
C. 3/4" wide, blue loop material with return hook tip for quick and easy adjustment wearer's comfort
D. 3/4" wide blue elastic material stretches for comfort
E. D-ring fastening system
F. A 1/4 watt, 2 megohm black molded external resistor
Tab to cup resistance:
10 to the 6th - 10 to the 7th Ohms @ 100 volts
For use with high heeled shoes
Will not mar shoes
Exceptionally tear resistant dual layer rubber with inner scrim
Provides long life - saving money
D-ring fastening system
Allows for flex during walking; less particulation and sloughing
2 megohm resistor
Always complies with UL and OSHA standards
Two-ply high abrasion, wear resistant rubber
Provides rapid and complete static dissipation
8 strand nylon polyester grounding tab
Does not particulate; superior body to ground contact
RG: 1 x 10E6 lt; 1 x 10E8 ohms per ESD SP9.2 7 ESD TR53
Made in the United States of America
Per ESD SP9.2 Appendix B - Foot Grounder Usage Guidance "Compliance verification should be performed prior to each use (daily, shift change, etc.). The accumulation of insulative materials may increase the foot grounder system resistance. If foot grounders are worn outside the ESD protected area testing for functionality before reentry to the ESD protected area should be considered."
Per ANSI/ESD S20.20 Paragraph 184.108.40.206 Personnel Grounding guidance, "ESD protective flooring, used with approved footwear, may be used as an alternative ot the wrist strap system for standing operations."
Per ESD Handbook TR 20.20 paragraph 220.127.116.11.4 Proper Usage "ESD protective footwear is designed to reduce body charge levels by supplying a conductive path from the body to the floor material. Heel and Toe grounders should be worn on both feet to insure effective use."
Prices subject to change without notice. Stock can change at any time. Prices are for online orders only. Stock items typically ship in 24-48 hours. Special orders with the manufacturer vary and are subject to their leadtimes.