This premium series heel grounder provides effective ESD protection. The cup is made from a black and non-marring rubber with inner tear resistant conductive scrim. The rubber is antistatic, low tribocharging, and dissipative. It removes charges when in contact with ESD protected floors. This foot grounder meets the less than 3.5 x 10 to the 6th ohm requirement of ANSI ESD S20.20. This unit includes either a one or two megohm molded external resistor, a conductive tab with carbon suffused fibers, and a D-ring fastening system. The product has been tested to ESD STM97.2 - Floor Materials and Footwear Voltage Measurement in Combination with a Person. It is a suitable ESD footwear component in Flooring - Footwear System when used as the primary grounding method (lt; 3.5 x 10 to the 7th ohms per ESD STM 97.1 Floor Materials and Footwear-Resistance Measurement in Combination with a Person).
A. 0.060" thick, 1.50" wide, black conductive exterior with a non-marring interior. Tear resistant nylon reinforced 4.3 oz. inner scrim layer prevents the rubber from tearing.
B. 3/8" wide, 30" long blue polyester tab contains electrically conductive carbon suffused fibers
C. 3/4" wide, blue loop material with return hook tip for quick and easy adjustment and wearer's comfort
D. 3/4" wide blue elastic material stretches for comfort
E. D-ring fastening system
Tab to cup resistance:
10 to the 6th - 10 to the 7th Ohms @ 100 volts
D-Ring Fastening System
Size adjustable material expands to fit most shoe sizes comfortably and flex during walking
Tear Resistant Rubber With Inner Scrim
Reinforced material prevents material from tearing – increasing the service life
30" Long, 8 Conductive Strand Nylon Polyester Grounding Tab
Additional conductive material provides realiable connection with operator’s sweat-layer
Non-Marring Interior Layer
Will not mar operator’s shoes
Two Megohm Series Resistor
To protect operator from accidental contact with equipment line voltage
Independently reviewed for adequacy of the product's design
Provides lot traceability to ensure quality control and tracking information
Made In The United States of America
Per ESD SP9.2 Appendix B - Foot Grounder Usage guidance "Compliance verification should be performed prior to each use (daily, shift change, etc.). The accumulation of insulative materials may increase the foot grounder system resistance. If foot grounders are worn outside the ESD protected area testing for functionality before reentry to the ESD protected area should be considered."
Per ANSI/ESD S20.20 Paragraph 184.108.40.206 Personnel Grounding Guidance, "ESD protective flooring, used with approved footwear, may be used as an alternative to the wrist strap system for standing operations."
ESD Handbook TR 20.20 paragraph 5.2.3 "If the contact area between the bottom of the foot and the floor is not continuous, charge generation may occur especially when a person is walking. Heel straps must be worn on both feet to minimize the amount of time that the body of the person is isolated from ground while walking."
Please note: this item is built-to-order. A minimum order of 200 is required if there is no stock currently on hand.
Prices subject to change without notice. Stock can change at any time. Prices are for online orders only. Stock items typically ship in 24-48 hours. Special orders with the manufacturer vary and are subject to their leadtimes.