Low profile
Helps keep employees from tripping on cord connection
10mm (0.395") snap
Easily snaps to 10mm mat spcket snap, flush to mat surface
Stud has threaded hole
6-32x1/4" flat head screw and countersunk washer are provided
Screw allows ground cord to be optionally bolted to mat
Keeps cord from disconnecting and ensures proper grounding
Fifteen feet of wire terminated
With a #10 (.200") ring terminal
Available with or without a one megohm resistor
Made in America
These items are primarily used for floor mats. They can also be used to ground bench mats and shelving.
NOTE:
Per ESD 6.1 "Provisions may be made to include a resistor where it may be required for a purpose other than ESD."
ESD Handbook TR 20.20 paragraph 5.1.3 Basic Grounding Requirements "The first step in ensuring that everything in an EPA is at the same electrical potential is to ground all conductive components of the work area (worksurfaces, people, equipment, etc.) to the same electrical ground point. This point is called the common point ground. The next step in completing the ground circuit is to connect the common point ground to the equipment ground (third wire, green)"
One Megohm resistor is required in wrist straps, however, the recommended practice is hard ground per ANSI/EOS/ESD S6.1 that is no resistor between the common point ground terminal and a worksurface floor mat, or shelving. Per ANSI/ESD S20.20 Table 1 Grounding System Technical Requirement, the Recommended Range is less than 1 ohm AC impedance.
|
Home
.jpg)
